Xenith Pro Dual Monitor Problem

  • This topic is empty.
Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #8112
    dzambazi
    Participant
    • Total Post: 1
    • Newbie

    Hello
    I’m follow this Forum a Long time now, and i learned a lot here.
    But now i have a Problem, i did not find a solution yet.
    We have Xenith Pro’s with two 24″ Monitors, wen i install the new Firmware 2.0_105, the left Screen goes right and the right one goes left, with about 800 Users, that would generate a lot of Calls.

    Did someone have the same Problem, how could i solve that.

    Greets

    #24555
    ConfGen
    Keymaster
    • Total Post: 10696
    • Jedi Master
    • ★★★★★★★

    Add Swap=yes to your dualhead parameter in the wnos.ini.

    CG

    #24571
    SnapN2AThinJim
    Participant
    • Total Post: 4
    • Newbie

    @ConfGen wrote:

    Add Swap=yes to your dualhead parameter in the wnos.ini.

    CG

    I have the same thing going on and was about to post the exact same question. This site rocks, thanks ConfGen.

    We have a xen.ini and wnos.ini file, each for their own hardware platforms. Why would this parameter need to go into the wnos.ini file for the Xeniths?

    Thanks in advance.

    #24573
    ConfGen
    Keymaster
    • Total Post: 10696
    • Jedi Master
    • ★★★★★★★

    Xenith do use mainly a xen.ini. But if there isn’t one, it looks for a wnos.ini also.
    ThinOS units only check for a wnos.ini.
    Therefore for ThinOS everything has to go in a wnos.ini. For Xenith units it just depends on what you are using. If you are using a xen.ini, then just add it there. If you are using a wnos.ini, add everything there.
    No need to use both, of course. This will not even work as a Xenith unit will never look for a wnos.ini, if it has found a xen.ini.

    CG

    #24661
    SnapN2AThinJim
    Participant
    • Total Post: 4
    • Newbie

    This firmware is causing headaches in our organization with the screens swapping. Historically, thin clients had been rolled out with Dualhead=yes and 2:VGA (blue) on left and 1:DVI (white) on right. What parameters will make the taskbar and icons on the right when the DVI is physically on the right? I’ve tried all of the below parameters and it’s just not setting it up for the user like they had it before the flash (with taskbar and icons on the right) and does not unswap.

    Dualhead=yes Mainscreen=1 Orientation=hort Taskbar=mainscreen 

    and

    Dualhead=yes Swap=yes Mainscreen=1 Orientation=hort Taskbar=mainscreen

    Your thoughts?

Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.