Wnos.ini across multiple models

  • This topic is empty.
Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • 20. March 2012 at 11:48 #7215
    Avatarscifidale
    Member
    • Total Post: 4
    • Newbie
    • ★

    Hi all,

    I’ve rolled out s10’s across our site but now have the requirement to deploy a couple of dual screen clients. I’ve been looking at the r10L’s as a possbility but wondered if my existing config would work. My s10’s pick up the wnos.ini from ftp and I do not use device manager, would it be possible to keep this config maybe with a slight adjustment to the wnos file?

    Regards
    Dale

    20. March 2012 at 12:48 #21948
    AvataraLiE
    Participant
    • Total Post: 320
    • Jacked into The Matrix
    • ★★★★★★

    S10 doesn’t supports dual/multi screen you will need a different hardware (like V10L, R10L etc.), depending on the model you will need a VGA/DVI splitter others have dual DVI and therefore no splitter is needed.

    20. March 2012 at 12:57 #21949
    Avatarscifidale
    Member
    • Total Post: 4
    • Newbie
    • ★

    thats what i meant if i bought some r10l’s would the existing wnos.ini work with minor adjustments?

    Regards
    dale

    20. March 2012 at 14:35 #21951
    AvataraLiE
    Participant
    • Total Post: 320
    • Jacked into The Matrix
    • ★★★★★★

    I din’t see your wnos.ini but yes with the R10L it will work, but depending on your server you will need Wyse TCX Suite to prevent programs spanning over 2 screens. If i would be you just leave the settings as it is just ajust the settings on the device itself, using this you can setup S10 with just 1 screen and have R10L with 2 screens just ajust the R10L’s device with multi monitor (dualhead) turned on.
    With Wyse TCX you can run your programs full screen on 1 screen, without it will span over both screens (depends on serverside 2003/2008)

    27. April 2012 at 0:19 #22171
    AvatarAmerist
    Participant
    • Total Post: 61
    • Back Stage Pass
    • ★★★★

    It can be done without TCX suite.

    Simply specify dualhead=yes in your WNOS.INI. Thin clients with one monitor will ignore it, those with two monitors can use it.

    We use a combination of C10LE, S10, V10LE, and R10LE (some dual monitor, some single) all with the same WNOS.INI

    Here’s the actual line we use in our WNOS.INI
    Dualhead=yes ManualOverride=yes

    27. April 2012 at 7:43 #22172
    AvataraLiE
    Participant
    • Total Post: 320
    • Jacked into The Matrix
    • ★★★★★★

    For the R10L you could also use 

    Dualhead=yes MonitorAutoDetect=yes

    this will only work with firmware 7.1.109 and higher and remember this setting is only for the R10L devices.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.