WDM ip configuration to Xenith

  • This topic is empty.
Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #6941
    khjoon
    Member
    • Total Post: 7
    • Newbie

    Good morning.

    I tried to change ip of Xenith by WDM work group editon, but failed.

    Process worked nomally,(When I changed IP on WDM and press ok, xenith noticed to user it would be reboot in 10 sec. and it did.)

    But IP is same which before I changed.

    WDM doesn’t support IP config for Xenith?

    PS : Where can I get firmware 1.7?

    #21370
    ConfGen
    Keymaster
    • Total Post: 11485
    • Jedi Master
    • ★★★★★★★
    #21374
    khjoon
    Member
    • Total Post: 7
    • Newbie

    @ConfGen wrote:

    For new firmware check here:

    http://www.freewysemonkeys.com/modules.php?name=Forums&file=viewtopic&t=7013

    CG

    Thank you for your answer. But how about IP configuration for Xenith in WDM?

    #21375
    ConfGen
    Keymaster
    • Total Post: 11485
    • Jedi Master
    • ★★★★★★★

    This is a known issue but works as design. Means, changing the IP is not supported.

    I guess you have an older WDM version installed, as this option was removed in 4.8.5.

    CG

    #21381
    khjoon
    Member
    • Total Post: 7
    • Newbie

    Thank you for replying CG.

    I think this question will be last.

    Then, is there any kind of document or something like that which can show me “WDM support to xenith these fuctions, and not those”?

    I found some table which compare to XPE, CE, linux but I could not find table about Xenith firmware.

    (And my WDM version is 4.8.5 but I can click “Change device Network setting”. Whatever, I will notice our client this feature is not available)

    again, thank you for your help.

Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.