WDM 4.7 and HTTP

  • This topic is empty.
Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • #5489
    Lagrane
    Member
    • Total Post: 10
    • Regular Joe
    • ★★

    I have installed WDM 4.7, setup WDM and IIS but when I try to Discover devices I get the following error message:

    HTTP discovery attempt failed. Unable to contact Web service

    When i check IIS all services are running. Does anyone have any ideas?

    Thanks

    #17069
    ConfGen
    Keymaster
    • Total Post: 11409
    • Jedi Master
    • ★★★★★★★

    Do you get an error message when you open the console? Something like “HServer is not running”

    CG

    #17075
    Lagrane
    Member
    • Total Post: 10
    • Regular Joe
    • ★★

    Nope, no error messages at all.

    #17076
    Lagrane
    Member
    • Total Post: 10
    • Regular Joe
    • ★★

    I did see that the Hservice was not started even though it was set to automatic. I started the service and when I trie to discover I now get the following message:

    Unable to initiate discovery. HTTP return Code:-10 SNMP Return Code -10.

    #17087
    ConfGen
    Keymaster
    • Total Post: 11409
    • Jedi Master
    • ★★★★★★★

    How long does it take until the HServer service is stopped again?
    It is OK that this service is stopped. it is an initialization service only.

    CG

    #17088
    Lagrane
    Member
    • Total Post: 10
    • Regular Joe
    • ★★

    About 20 seconds

    #17089
    ConfGen
    Keymaster
    • Total Post: 11409
    • Jedi Master
    • ★★★★★★★

    That’s much to long. If everything is OK, it should only last 3-5 seconds. Every second more indcates an issue with the HServer.

    I would recommend to deinstall WDM AND IIS. Then install IIS followed by WDM again.

    CG

    #21689
    kmdragon100
    Member
    • Total Post: 1
    • Newbie

    i wonder if u revolve the problem in the error:

    Unable to initiate discovery. HTTP Return Code:-SNMP Return Code:- 10
    ???

    And how did u do it

    thansk a lot for your help

    #23675
    manuel
    Member
    • Total Post: 1
    • Newbie

    Hi , I have the same issue !
    How did you solve the problem ??
    Thank you

Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.