USB Key imaging does not set password on new factory V90s

  • This topic is empty.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #528
    Schnark
    Member
    • Total Post: 16
    • Regular Joe
    • ★★

    Hi all,

    I’ve got the ol’ USB key imaging cranking up and when I deploy the same image to two new V90s, one via USB key and one via Rapport, while it will configure the BIOS on the USB key version to the desired settings, it wont set the password. The Rapport delivered version works fine and sets the password.

    Can someone plz advise what the setting on the USB key image that says to set the password in the BIOS or not?

    #9922
    thinkthin
    Member
    • Total Post: 1649
    • Jacked into The Matrix
    • ★★★★★★

    Thanks a good one!

    Are you sure the other BIOS settings are saved (like boot order) and not just the password? I will have to test this as if the 9V90 push.i2c files contains the line =YES it should push the BIOS with the settings.

    Hmm, I will check it out…

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.