Symantec EndPoint 11.0

  • This topic is empty.
Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #2299
    patrick_maloney
    Member
    • Total Post: 4
    • Newbie

    Is anyone using Symantec Virus Protection for their Thin-client Devices? We are looking at EndPoint 11.0.

    Thanks

    #18472
    saurabh
    Member
    • Total Post: 1
    • Newbie

    As far as I believe Symantec Endpoint protection is too big to be installed on a WYSE.

    #18773
    ek
    Member
    • Total Post: 5
    • Newbie

    We have managed to load Symantec on the R90L (2G Flash /1G RAM).
    You have to change the RAM Drive to 99Meg.
    Use a memory stick and change your environment variables to point to the memorystick
    Install Symantec
    Enable Write Filter.
    Add the following exclusion in Write filter ( for program and sig updates)
    c:Doc and UsersAll usersapplication dataSymantec
    c:program filesSymantec
    c:Doc and Settingsprogram filescommon filesSymantec
    c:Doc and UsersUserlocal settingsapplication dataSymantec
    c:Doc and UsersAdministratorlocal settingsapplication dataSymantec
    change the environment variables back to z:

    #24595
    keitre
    Member
    • Total Post: 26
    • Regular Joe
    • ★★

    hi Ek,

    May I know how did Symantec performed after your installation? one of our customer is experiencing low memory warnings after installation. they are using D90D7 with 16GB Flash and 4GB Ram.

    regards,

    keith

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.