S30 Wyse simple imager

  • This topic is empty.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #744
    Avatarmphlips
    Member
    • Total Post: 1
    • Newbie

    I’ve tried to bring several S30’s back to life with Simple imager. They connect fine and start to pull the firmware but it always locks up on the following step.

    Searching for: (mbr.bsc)
    ‘mbr.bsc’ to ‘stream/ide-0-0/’

    #10792
    ConfGenConfGen
    Keymaster
    • Total Post: 11009
    • Jedi Master
    • ★★★★★★★

    Hi mphlips,

    check the partnumber of your S30s. If it ends with an “L” then you have to use “S32” within Simple Imager and not S30.
    S30=old S30
    S32=new S30 RoHS compliant

    Cheers
    ConfGen

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.