S30 ICA Connection not holding autoLogon password

  • This topic is empty.
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #7992
    AvatarHeagz
    Member
    • Total Post: 29
    • Frequent Flyer
    • ★★★

    He guys, hopefully someone can shed some light on this issue. We have an S30 with a 669 build (also tried many others). When we edit our ICA connection, we go into the Logon tab and put in the username and password, then click OK. After connecting, the password does not pass and is removed from the “pasword” field in the Logon properties. You have to type the password manually into the connection screen prompt, and it passes without issue. we have some in the field that are working just fine that are older, tried pulling the config off of those working and pushing it down to the same firmware versions, no luck. Does anyone know how to get the password to stick in the Logon field. The user name stays without issue. Also, if the network cable is disconnected and the connection fails, the password stays. Strange stuff, any help would be appreciated, thank you.

    ..sorry about posting in the wrong area:) fat moused it.

    #24213
    ConfGenConfGen
    Keymaster
    • Total Post: 9810
    • Jedi Master
    • ★★★★★★★

    Could it be a NLA issue?

    CG

    #24221
    AvatarHeagz
    Member
    • Total Post: 29
    • Frequent Flyer
    • ★★★

    I woudn’t think so because there are a few terminals out there where this does work, which is on 581 FW, not sure though. The strange thing is that if we image a new one, push the 581 firmware down, we cannot get it to stick. If we grab the whole image as a bundle from the field and re-image one with that, it sticks. Not sure what part of the bundle that is allowing the password to stick, compared to when we use the same firmware fresh, and it does not stick. We can at least use the whole bundle now, but I have no clue what is allowing it to stick.

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.