R50L – Can’t force Single User Display

  • This topic is empty.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #4535
    Vaart
    Member
    • Total Post: 1
    • Newbie

    We start up the R50L and go to
    +Control Center
    +Advanced Display Setting
    +Display Manager
    +Display Area ( standard setting = preferred )

    If we start up a RDP Session it goes dual screen, but there is no dual screen ( only one).
    If we set preferred to 1680X1050 and start up the same RDP it starts on the one screen that’s available. “Thats what we need”

    We can’t find the setting in the WLX.ini that forces de Display Area to be 1680X1050.

    We tried ? :
    dmonitor.enabled=no
    onmonitor=1
    resolution=1680×1050

    Can someone help us out ?
    Any suggestions ?

    #16560
    ConfGen
    Keymaster
    • Total Post: 11423
    • Jedi Master
    • ★★★★★★★

    Resolution=1680×1050 should be enough. All others aren’t supported at that time. So remove the
    dmonitor.enabled=no
    onmonitor=1
    parameters and try again.

    CG

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.