Phoenix Flash Error when deploy image Wyse on Z90D7

  • This topic is empty.
Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 25, 2012 at 11:09 am #7561
    daviv78
    Member
    • Total Post: 6
    • Newbie
    • ★

    Hello,

    When i deploy with merlin a new image BZB0_0831_4096_Fr (download from Wyse Support download), i have an error on some Thin Client Z90D7.
    The error is after push image in phase of flashing:
    Phoenix Flash error – do not supported cmd ‘-PpaH’ – Press any key for reboot.
    If press anykey, system reboot after 5 seconds. Then sysprep WES7 start.
    Can you help me please?
    thank you very much.

    October 25, 2012 at 3:15 pm #22917
    ConfGen
    Keymaster
    • Total Post: 10696
    • Jedi Master
    • ★★★★★★★

    Do you also get the error when you only push the image and not image+BIOS/CMOS?

    CG

    October 25, 2012 at 3:40 pm #22918
    daviv78
    Member
    • Total Post: 6
    • Newbie
    • ★

    Hi,

    Oh yes!
    I see this
    I corrected it and I retest.
    I resenseignerai my post with the result
    thank you very much!

    October 29, 2012 at 7:42 am #22927
    daviv78
    Member
    • Total Post: 6
    • Newbie
    • ★

    Hi,
    Thanks a lot, the wizard capture enable image+Bios/cmos by default.
    I disable all for only capture os.
    It’s OK now.
    Thanks
    Bye

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.