Linux v6 goes to High Resolutions after factory default

  • This topic is empty.
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #1582
    enam
    Member
    • Total Post: 144
    • Legend in Own LunchBox
    • ★★★★★

    Hi,

    All new version of WYSE Linux v6 goes to High Resolutions (1280×1024)after reseting the device factory default. Old CRT monitors does not support high resolution.

    How can avoid the devices to go on high resolutions.

    Regards,
    Enam

    #14369
    ConfGen
    Keymaster
    • Total Post: 11428
    • Jedi Master
    • ★★★★★★★

    You should have to edit the etc/conf.d/config.default
    I always thought that the default was DDC but maybe they have changed it.

    CG

    #14376
    enam
    Member
    • Total Post: 144
    • Legend in Own LunchBox
    • ★★★★★

    Hi,

    The file is etc/conf.d/system.default

    system.default file contain the perameters for monitor resolution is.

    [Desktop]
    Resolution = 800×600
    Depth = 16
    Refresh = 60
    Resolution Venus = xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx

    But when I reset the device to the factory default it goes on 1280×1024.

    Is there any other option to change the system default resolution 800×600 after reseting the device to the factory default.

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.