Help with a Wyse 9235LE that BSoDs on boot.

  • This topic is empty.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #6693
    AvatarIcedCube
    Member
    • Total Post: 1
    • Newbie

    Hello,

    I purchased a Wyse 9235LE from eBay and it seems to be in really good nick. The problem is, that when I boot it up, it does the whole amber light, verify Flash Memory and power off trick. I turn it back on and it boots up fine, but when it gets past the initial XP Loader progress bar the one show just after the BIOS screen that says “RAM Installed: 256000k @ 100Mhz” etc it bluescreens with a horrible 0x0000007B Error Code! (I think it has something to do with can’t find boot device?)

    My 9235LE seems to have 268MB (or is that 256MB?) of NAND Flash, as judging from this picture that I captured, it says Drive 0: 268MB.

    So, what can I do? ❓
    I am tempted to flash it with one of the images listed here, but I am not sure what image I should use. I don’t want to botch up this thin client, as I’m using it for a project. 😕

    Here’s a quick rundown of what happens:


    …then…

    …then…

    So, please advise on what plan of attack is the best. I guess the Winterm’s life rests in the hands of the community advice…

    Cheers,
    IcedCube

    #20624
    ConfGenConfGen
    Keymaster
    • Total Post: 11116
    • Jedi Master
    • ★★★★★★★

    Depending on where you are living in the world you should take either Image #3 or #6

    CG

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.