guest account auto login loop

  • This topic is empty.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #6012
    jpatr
    Member
    • Total Post: 1
    • Newbie

    Hi, I’m testing the wyse Cx0 with SLED 11 OS for our company. I setup the guest account to auto logon and I can’t figure out how to switch to the admin login to make changes. What’s the best way to switch over to the admin account. Also, how do I access single user mode to get to a command line on bootup?

    Thanks,

    #18742
    ConfGen
    Keymaster
    • Total Post: 11425
    • Jedi Master
    • ★★★★★★★

    You will have to do a factory reset as there is no way to configure this via GUI. If you would use the wlx.ini then you could configure a autologin countdown and use this time to login as an admin.

    Here’s the procedure for g-key reset on R50L with V11.

    1) Reboot and when bios screen shows, hold down the escape key. This should bring up the Grub boot menu.
    2) From the Grub boot menu, choose the 2nd entry down (not the fastboot, which is default)
    3) After the green screen with the progress bar is showing, wait a few seconds and start holding down the g key.
    4) when booting is complete, the permanent registry should be reset to default, and, the admin and thinuser passwords should be reset to default.

    CG

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.