Burning CDs

  • This topic is empty.
Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 23. August 2007 at 16:27 #568
    AvatarNRT
    Member
    • Total Post: 11
    • Regular Joe
    • ★★

    I’ve got an out of the box Wyse V90 with a USB CD Writer attached.

    CDs are being detected so the CD Reading is working ok. But I can’t get the cd writing working, idealy I’d like to use the burning software built into Windows XP.

    Any help or guidance would be appreciated.

    Regards

    Neil.

    23. August 2007 at 22:14 #10038
    Avatarthinkthin
    Member
    • Total Post: 1707
    • Jacked into The Matrix
    • ★★★★★★

    Hi Neil,

    I would forget about CD writing as there is not enough space to cache the image. The Windows CD software is not in the image as its never used.

    Also CD writing is not supported under RDP/ICA,

    Cheers,
    -TT

    23. August 2007 at 23:58 #10039
    AvatarNRT
    Member
    • Total Post: 11
    • Regular Joe
    • ★★

    I’m not looking to write 100s of megs onto a CD, I’m guessing I’d be limited to 30-60mb. So that’s not a problem and with the data being transfered to the Wyse terminal, the question of CD writing being supported over ICA/RDP isn’t relevant in this case.

    So is it possible to add the CD writing software to the image?

    24. August 2007 at 7:08 #10040
    Avatarthinkthin
    Member
    • Total Post: 1707
    • Jacked into The Matrix
    • ★★★★★★

    Maybe grab the Nero trial software and see if it installs?

    Cheers,
    -TT

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.