1200 not powering up

  • This topic is empty.
Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • 29. June 2008 at 23:33 #1305
    AvatarSammy
    Member
    • Total Post: 28
    • Regular Joe
    • ★★

    Hi,

    I am just wonder if anyone has come across a 1200 beeping when you put the power plug in, the Nic has lights, but can’t power up the unit. its the 1st time i am coming across this – so any information would be great.

    thanks

    30. June 2008 at 6:55 #13395
    Avatarthinkthin
    Member
    • Total Post: 1707
    • Jacked into The Matrix
    • ★★★★★★

    Hi,

    Could be the resolution is set to high for the monitor?

    Press and hold the “V” key and power on the unit, this should re-set the video.

    You could also try to VNC to the unit via MAC address,

    Cheers,
    -TT

    30. June 2008 at 19:56 #13400
    AvatarSammy
    Member
    • Total Post: 28
    • Regular Joe
    • ★★

    thanks TT,
    But i think the unit is at a worse state than that. – the unit beeps when i plug the AC adapter in – and the unit doesn’t get to power up, even though i can see lights on the Nic.

    The power light doesn’t come on at all. 🙁

    1. July 2008 at 6:11 #13405
    Avatarthinkthin
    Member
    • Total Post: 1707
    • Jacked into The Matrix
    • ★★★★★★

    OK, you never no. I have also seen 1200LE’s where the video card has blown. I found I could see the unit get an IP and then VNC to it but know video.

    If its in this state or will not boot you will have to send it to a Wyse Authorised Repair Center,

    Cheers,
    -TT

    1. July 2008 at 20:14 #13409
    AvatarSammy
    Member
    • Total Post: 28
    • Regular Joe
    • ★★

    Thanks TT,

    I had a feeling someone was going to say that. 😥

    never mind. will get sorted.

    cheers

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.