Reply To: Wyse Simple Imager assistance needed

#9275
drudrewdizzy
Member
  • Total Post: 19
  • Regular Joe
  • ★★

A couple of items to check:

-Be sure to static the IP, install DHCP and define scope, and then install WSI all while the cross-over cable is attached to a thin client w/ an active NIC? This is important for binding the NIC to the IP address and so on.
-It’s always best to uninstall WSI and try again, this usually resolves any connectivity issues.
-Make sure all firewall services are disabled and DEP (if applicable) is only set to protect Windows system files.

Check out solution 13160 – http://www.wyse.com/serviceandsupport/support/kbase.asp