Reply To: Pulling an Image HELP!!!

#13374
ConfGen
Keymaster
  • Total Post: 11368
  • Jedi Master
  • ★★★★★★★

The following steps should work for you:

1) close WSI
2) disable DHCP Proxy Service
3) make sure TFT32 is running
4) open cmd and change to c:inetpubftprootrapporttoolssaalone
5) alone pull
Example: alone pull 9V92 V90LE_Custom
6) power on the Unit, it will pick up the TFTP-Bootfloppp and start pulling off the image
7) after the imaging is done, the .i2d is in the new subdirectory under ftprootrapport
8) if you want to pull the image again at a later time, mike sure the c:inetpubftprootrapporttoolssalogfiles subfir is empty